Functions:
Spectrocolorimeter
Spectrodensitometer
Monitor Calibrator
Spectral Camera
Spectrocam
Spectrographic
measurement of colors:
The Spectrocam is a true spectrophotometer, measuring the complete
visible spectral range of 380nm to 750nm. These spectral data give
you the most accurate and detailed definition of color. In comparison
to densitometers, spectrophotometers are more accurate, are less
susceptible to media differences and measurements taken with different
units are more consistent between each other. Besides, the Spectrocam
delivers you all the densities and colorimetric values you need
based on true spectral data.
Xenon
illumination:
Xenon day light flash was only available in very expensive spectrophotometers
- until now. It enables the measurement of fluorescence as it is
observed in real daylight. And the effect of fluorescent whitening
agents, so widely used in paper nowadays, is detected more accurately
than with spectrophotometers using incandescent lamps or LEDs for
illumination.
Annular
45°/0° measuring geometry:
The Spectrocam is ISO standard compatible with its 45°/0°
measuring geometry. The surface is circular illuminated under 45°and
the reflection is measured under 0°. In this way colors are
more accurately measured regardless of the gloss and orientation
of the surface texture, an issue when using spectrophotometers with
a different measuring geometry.
75
bands:
The Spectrocam is a 75 bands spectrophotometer measuring the color
spectrum from 380 nm to 750 nm in steps of 5 nm. This allows for
an even more accurate measurement than measurements taken with the
typical 36 bands or less.
Measurement
averaging:
The Spectrocam takes 35 measurements per second, which makes it
possible to average of 4 to 16 readings into one precise measurement
value unlike any other spectrophotometer on the market.
Fast measurements
The Spectrocam is the fastest handheld spectrophotometer on the market
with 35 measurements per second, even faster than other well known
motor driven scanning spectrometers. You can scan over 100 patches
per minute, which makes the Spectrocam the ideal tool for color management,
where often color charts of 400 patches and more need to be measured
for generating profiles. The measurement speed also enables higher
accuracy by taking multiple readings per patch which are averaged
into one precise measurement value. It is this combination of speed,
accuracy and multi-functionality that sets the Spectrocam apart from
any other spectrophotometer on the market today.
The Spectrocam combines the functions of four instruments
in one. There is no need to buy separate expensive color
measurement instruments for each task anymore. Just use
the Spectrocam which gives you the superior accuracy of
a spectrophotometer:
1. Scanning Spectrophotometer
 |
The Spectrocam is the fastest miniature spectrophoto -meter on the
market today, even faster than well known motor driven scanning
spectrophotometers but only at a fraction of the cost. A bar of
18 color patches can be scanned in less than 10 seconds. No need
to cut up your test sheet or to position it precisely on a scan
bed. Just position the scan ruler and move the Spectrocam through
the slot. |
2. Spectro Colorimeter and Densitometer
 |
The Spectrocam provides the functions of a colorimeter and densitometer
using true spectral data. The Spectrocam features a Xenon daylight
flash that was only available in very expensive spectrometers -
until now. Xenon enables you to measure fluorescence exactly as
it is observed in real daylight. The Spectrocam gives you the densities
and colorimetric values you need: CIE XYZ, xyY, Luv, Lab, LCH,
HSB, RGB, print densities: Status A, T, E, I, DIN 16536-2. |
3. Monitor Calibrator
 |
Whatever monitor you use, get the best and most color true picture
on your screen by calibrating your monitor regularly with the
Spectrocam.
And needless to say, it is fast again. Start the calibration program
and hold the Spectrocam in place on your LCD or CRT screen for a
total measuring time of 30 seconds: less than the time needed to
clean the suction cup stains off your screen after using a conventional
calibration probe. |
4. Spectral Camera – determine the color temperature
|
The Spectrocam also functions as a spectral camera, measuring
the color temperature of light emitted from a light source or
reflected from an object. With the Spectrocam you can determine
the light conditions for checking your print materials or slides.
|
| |
Part Number |
Price |
| Spectrocam: Includes software |
EQP-IHSC |
$1800.00 |
Ask about our 14 day trial!
Revised December 2006
Prices subject to change
without notice.
FOB ship point, factory.
All major credit cards accepted
